Parkervision WR1500 User Manual download pdf (Page 64)

WR1500 4-Port Wireless DSL/Cable Router

8.4 Conﬁ guring WAN IP - Continued

The following table describes the labels on the screen on the preceding page.

LABEL

DESCRIPTION

WAN IP Address Assignment

Get automatically from ISP

option

Select this selection

if your ISP did not assign you a ﬁ xed IP address. This is the

default

Use ﬁ xed IP address

Select this option If the ISP assigned a ﬁ xed IP address.

My WAN IP Address

Enter the WR1500 Wireless Router WAN IP address in this ﬁ eld if you selected

Use Fixed IP Address.

My WAN IP Subnet Mask

(Ethernet encapsulation)

Enter the WR1500 Wireless Router WAN IP subnet mask (if your ISP gave

you one) in this ﬁ eld if you selected

Use Fixed IP Address.

Remote IP Address (or Gateway

IP Address)

Type the IP address of the remote network or gateway. The gateway is an

immediate neighbor of your WR1500 Wireless Router that will forward the packet

to the destination. On the LAN, the gateway must be a router on the same

segment as your WR1500 Wireless Router; over the WAN, the gateway must be

the IP address of one of the remote nodes.

Remote IP Subnet Mask (PPPoE

and PPTP encapsulation)

When using a LAN to LAN application, type the IP subnet mask of the

destination network. If you need to specify a route to a single host, use a

subnet mask of 255.255.255.255, in the subnet mask ﬁ eld, to force the

network number to be identical to the host ID.

Network Address Translation

Network Address Translation (NAT) allows the translation of an Internet protocol

address used within one network to a different IP address known within another

network.

SUA

(Single User Account) is a subset of NAT that supports two types of

mapping:

Many-to-One

and

Server.

When you select this option the WR1500

Wireless Router will use Address Mapping Set 255 in the SMT.

Choose

SUA Only

if you have just one public WAN IP address for your

WR1500 Wireless Router. Choose

Full Feature

if you have multiple public

WAN IP addresses for your WR1500 Wireless Router. For more information

about NAT refer to the MAT chapter in this

User’s Guide.

Metric (PPPoE and PPTP only)

Type a number that approximates the cost for this link. Metric represents the

“cost” of transmission for routing purposes. IP routing uses hop count as the

measurement of cost, with a minimum of 1 for directly connected networks. The

number need not be precise, but it must be between 1 and 15. In practice, 2 or 3

is usually a good number.

Private (PPPoE and PPTP

only)

This parameter determines if the WR1500 Wireless Router will include the

route to this remote node in its RIP broadcasts. If select

Yes,

this route is kept

private and not included in RIP broadcast. If select

No,

the route to this remote

node will be propagated to other hosts through RIP broadcasts.

Continued on next page

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 176 177

Comments to this Manuals

No comments

Parkervision WR1500 User Manual Page 64

Comments to this Manuals